Posted: Wed Jan 11, 2012 5:32 pm Post subject: tremel-no advice
I want to install a tremel-no on my rasmus GG, To do this I have to put the springs parallel to each other. Right now the two outside springs are on an angle. will putting them straight affect my set-up? _________________ "all the fun of the fair"
Well it's going to change the length of the springs, therefore the tension, so yes. By how much, depends on your current setup/string gauge/neck relief etc. Have it done by someone who knows what they are doing.
Joined: 24 May 2005 Posts: 132 Location: Lincolnshire, UK
Posted: Sun Jan 15, 2012 11:25 am Post subject:
+1 if in doubt get some proper help.
You're going to have to change your spring claw anyway...just take a note of how parallel to the body your bridge is sitting...that's where you want to end up post-installation. _________________ SoundCloud
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum